BOXLIGHT MP-25t Guide de l'utilisateur télécharger pdf (Page 23)

– 23 –

REMOTE CONTROL BATTERY INSTALLATION

Remove the battery

compartment lid. 2

Slide the batteries into the

compartment. 3

Replace the compart-

ment lid.

Note: For correct polarity (+ and –

terminal), be sure the battery

terminals are in contact with

the pins in the compartment.

USING THE REMOTE CONTROL UNIT

Point the remote control toward the projector (Receiver window) whenever pressing the buttons. Maximum operating range

for the remote control is about 16.4’ (5m) and 60° front and rear of the projector.

To insure safe operation, please observe the following precautions:

¡Use (2) AA type alkaline batteries.

¡Change two batteries at the same time.

¡Do not use a new battery with a used battery.

¡Avoid contact with water.

¡Do not drop the remote control unit.

¡If batteries have leaked on the remote control, carefully wipe the case clean and load new

batteries.

16.4’

(5 m)

16.4’

(5 m)

60°

Downloaded From projector-manual.com Boxlight Manuals

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Pas de commentaire

BOXLIGHT MP-25t Guide de l'utilisateur Page 23