Boxlight CP-300t Manuel d'utilisateur télécharger pdf (Page 36)

SETTING

This function turns Projection Lamp off when this projector detects

signal interruption and is not used for a certain period in order to

reduce power consumption and maintain the Lamp-life. (This

projector is shipped with this function ON.)

Power Management function operates to turn Projection Lamp off

when the input signal is interrupted and any button is not pressed

over 5 minutes. This function operates as follows;

1. When any input signal is interrupted, “No signal” and the

counting down display appears (for 5 minutes).

2. When Projection Lamp turned off, READY Indicator turns off.

Cooling Fans operate and Projection Lamp is turned off for 90

seconds. (During this "Cooling Down" period, projector cannot

be turned on.)

3. When Projection Lamp has cooled down, READY Indicator

flashes and Projection Lamp can be turned on again (Power

Management mode).

In this Power Management mode, Projection Lamp is

automatically turned on when the input signal connected or

projector is operated with any button on Top Control or on

Remote Control Unit again.

Power management

This function is used to reset Lamp Replace Counter. When

replacing Projection Lamp, reset Lamp Replace Counter by using

this function. Refer to page 39 for operation.

Lamp counter reset

Remote control

This projector has two different remote control codes; the factory-set

normal code (Code 1) and the secondary code (Code 2). This

switching function prevents remote control operation mixture (jam)

when operating several projectors or video equipment together.

When operating projector in “Code 2,” both projector and Remote

Control Unit must be switched to “Code 2.”

To change the code of Projector;

Set Remote control in the SETTING MENU to “Code 2.”

To change the code of the Remote Control Unit;

Press both MENU and IMAGE buttons on Remote Control Unit

together for over 10 seconds.

After changing the code, make sure Remote Control operates

properly.

To return to the normal code (Code 1), operate both projector and

Remote Control in the ways above again.

NOTE : When batteries of Remote Control Unit are replaced or ALL-

OFF switch is turned to “ALL-OFF,” the remote transmit

code automatically returns to the normal code (Code 1).

On start

When this function is “On,” projector is automatically turned on just

by connecting AC Power cord to a wall outlet.

Note ; Be sure to turn projector off properly (refer to the section

“TURNING OFF THE PROJECTOR” on P19). If projector is

turned off in the wrong steps, On Start function does not

operate properly.

Time left until Lamp off.

Move the pointer to the item and

then press POINT LEFT/RIGHT

button(s).

Move the pointer to Lamp counter reset and then press

SELECT button. The message “Lamp replace counter

reset?” is displayed.

Press SELECT button at this icon to

display other items.

Press SELECT button at this icon to

display previous items.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire

Boxlight CP-300t Manuel d'utilisateur Page 36

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Boxlight CP-300t